The 5-axis cutting head, developed by Mavijet for the most precise angled cuts, allows our clients to perform tasks in the simplest and most efficient way from 10 to 45 degrees. By combining the 5-axis cutting head with modern CNC, impressive part geometries can be manufactured from any material.
| Parameter | Unit | MJT-W3-3020 |
|---|---|---|
| Table size | mm | 3000 × 2000 |
| Head lifting height | mm | 250 |
| CNC system | — | 5+1-axis control system; Ethernet and network interfaces; USB port; manual pulse generator (X, Y, Z) |
| Motor power – X axis | — | 3.2 Nm Servo, 1 pc. |
| Motor power – Y axis | — | 3.2 Nm Servo, 2 pcs. |
| Motor power – Z axis | — | 1.6 Nm Servo, 1 pc. (with brakes) |
| Motor power – C axis | — | 1 Nm Servo, 1 pc. |
| Motor power – A axis | — | 1 Nm Servo, 1 pc. |
| Motion system – X, Y axes | — | Hardened screw racks and pinions |
| Motion system – Z axis | — | Ball screw (ballscrew) |
| Motion system – A, C axes | — | Hinged belt drive |
| Guideways | — | Linear guideways and racks (THK-JAPAN) |
| Travel accuracy | mm | 0.01 |
| Positioning accuracy | mm | 0.02 |
| Rapid traverse speed | mm/min | 30,000 |
| High-pressure unit MJT-4000 | — | — |
| Pressure | bar | 4000 |
| Motor | HP | 50 |
| Speed | rpm | 1500 |
| Flow rate at maximum pressure | l/min | 3 |
| Pump displacement | cm³ | 71 (103 l.) |
| Axial piston pump pressure | bar | 200 |
| Optimal inlet water pressure | bar | 4 |
| Water pump pressure | bar | 8–10 |
| Abrasive hopper | — | — |
| Capacity | kg | 350 |
| Required air pressure | bar | 6 |
| Sand dosing system | — | Controlled from the CNC system using a pasometer |
| Sand dosing system – cutting head and mixing chamber | — | — |
| Sand consumption (depending on material type) | g/min | 80–600 |